kermitt

Sent my head to get reconditioned and skimmed as part of the engine rebuild and have been informed my cams knackered and need a new one.

Was hoping this would not be the case as am trying to save for an intercooler at the same time as fund the rebuild. The car is mildly tuned CVH standard head and block running stage 2 T3, magnex and chip.

Can you stil get these from Ford or am I looking after market, if so who from?

project rs

just go to any car spares place and get an aftermarket one cost around 75 for kit or off ebay

xr2wishy

iTrader: (2)

as above, that's all i'm using in my zvh, dialled it in with a vernier pulley though.
had enough of piper and kent diying young.
newmans is on the list for the future after an mtx75 conversion though

kermitt

Have never used a vernier pulley before but have been considering getting one, how do you set it up on a standard cam profile?