andy130

iTrader: (2)

who is the best to take my frst to for a setup, and a rought price aswel?
thanks

clarke5700

if you dont mined driving i would say janno fair priced as well

andy130

iTrader: (2)

i will take it any where as long as they do a great job,

orionmojo

iTrader: (1)

NMS for RSTurbos. All the way.

lurch1977

iTrader: (1)

MSD couple of hundred quid cannot go wrong.

Chip

iTrader: (3)

NMS seem to have more of an interest in RST's than most places, and no one can doubt that Karl knows his stuff, I would say you would be in very safe hands there.

But Stu@MSD is a lot closer to the ferry from ireland (he is in blackpool) and also very well respected on here.

Depends on the spec really, if its a relatively modest conversion im sure Stu will be perfect for you and is easy to get to, if its massively modified Karl probably knows the CVH better than just about anyone else in that context!

orionmojo

iTrader: (1)

Its not really that much of a difference. theres probably less than 20 miles in it. You've got to navigate round the coast to get to blackpool, or a few A roads to get to derby.

*p.s.* i'm talking from holyhead, incase you meant somewhere else?

Rob_DOHC

iTrader: (4)

Has any one got any good/bad experiences ect. with torque of the devil? Thinking of going for a set up in a few weeks and they are pretty damn close....

rs cab

Andy i could highly recommend NMS, i brought mine over last year, it was like i had a different car on the way back. Took around 3 hours from Holyhead.

Karlos G

iTrader: (4)

Chris Todd from TOTD does know his stuff, took mine there a couple of years ago cant fault him, good Dyno Dynamics rollers too so a fairly accurate figure will be calculated!

Here's my motor there......... http://www.youtube.com/watch?v=eIcu6gf44Lk

Rob_DOHC

iTrader: (4)

Im booked in for friday morning at torque of the devil so i shall let you all know how it goes, sounded like a friendly bunch on the phone!

Rob,