zvh
#1
zvh
hy
i am building a 1.8 zvh and i am going to juse the standard pistons
but how much do i have to machine them off????
i read 0.5mm butt this seems so little
( it's going to run about 0.8 bar )
grtz from belgium
i am building a 1.8 zvh and i am going to juse the standard pistons
but how much do i have to machine them off????
i read 0.5mm butt this seems so little
( it's going to run about 0.8 bar )
grtz from belgium
#2
I've found that life I needed.. It's HERE!!
Have a read of this page:
http://www.quantums.info/zvh.htm
I found it quite a good read and interesting when I was looking to understand more about them. I believe he suggests machining 0.5mm off the standard pistons.
Lee
http://www.quantums.info/zvh.htm
I found it quite a good read and interesting when I was looking to understand more about them. I believe he suggests machining 0.5mm off the standard pistons.
Lee
Thread
Thread Starter
Forum
Replies
Last Post