this little goody



Alex (aka Buey 2 on STOC) has just fitted this, remap to follow

Im well chuffed for him

Rich

and for those thinking huh? - its the ST220 3L V6 engine in a ST200

 

Oh yes

 

quality,wots that . . .round about 222bhp of v6 music !!!!

 

ST220 power specs are usually underated, might possibly see 240bhp from it, maybe nearer 300bhp if he is able to do similar mods to those Dan Brown has done (ST220 297bhp)

also, isnt the 200 lighter than the 220 as well?

 

his car has been mapped and rolling roaded at 244bhp - its due another remap so may even put out a bit more.

not bad from a 'reps' mobile eh ?

 

thats bloody awesome.

and info on how difficult the conversion was???? how much torque is the engine putting out???

 

its taken about 9 weeks from start to finish, but I think it was weekends and some evenings. I dont have any details on what jobs needed doing, but it was a straight fit, no bulkhead mods were needed. Some of that time was taken as it had to go in to Fords to have a ex/manifold stud refitted as it was damaged at some point.

No graphs done yet (will be some after next remap) but its putting out typical ST220 figures

I will update on any changes

hopefully a janspeed 4 branch manifold and a few other bits and bobs will be added to his shopping list - would get it up to 290-295bhp normally aspirated (same as Dan Brown's ST220)..

 

looks great, when you say it was straight forward and no mods it was really that easy just bolts in and wires up u didnt change the loom??