mtx to mk4 escort hubs shafts wanted
#2
Advanced PassionFord User
Doesn't crazycage sort these things out?
#3
PassionFord Post Whore!!
Crazycage is the man you need to talk to
#5
PassionFord Post Whore!!
Thats bad news
Trending Topics
#8
10K+ Poster!!
Prop shaft services near Hounslow would make them up for you if you have both ends.
Many people do make their own by cutting up the bits they need and then plug welding a sleeve over...might do until you can find a solution.
Many people do make their own by cutting up the bits they need and then plug welding a sleeve over...might do until you can find a solution.
#10
10K+ Poster!!
Can you not mount the gearbox/ engine and hubs and then offer up each side cut with a sleeve over, measure and have welded. You may need a pair to waste as you really want both ends of the shafts butted up, I believe they can cold weld them (or something like that)
Even two wooden ends with a wooden brush shaft to get the length and then compare to both ends of shaft?
Even two wooden ends with a wooden brush shaft to get the length and then compare to both ends of shaft?
#12
10K+ Poster!!
I only really have the cossie shafts experience to work on buy that would be about 30 to 40mm. On the cossie the inner cups have a spring in them so you can work out the tolerance from fully compressed to not.
#13
10K+ Poster!!
If you can get each shaft end cheap enough you could remove the suspension spring and make up a slider in the middle of a trial shaft and move it around all extremes, you wouldn't be too far out that way.
#14
PassionFord Post Whore!!
Can you not ask Crazycage for lengths?
You need both Mtx shafts and I think 2 x n/s solid Escort shafts
You need both Mtx shafts and I think 2 x n/s solid Escort shafts
#16
10K+ Poster!!
Have you got a mig for welding? Worth getting to just tack stuff together and let the experts take over
Thread
Thread Starter
Forum
Replies
Last Post
Christian and Beccy
General Car Related Discussion.
9
19-09-2008 09:35 PM