dan m8 it was just over 200 bhp it had a stg 3 hybrid on it head was ported it was chipped scorpion exhaust k&n plus other bits and bobs.If youlook in the trim shot you can just make out the bias valve i put in to sort out the rear discs, the hoses was goodridge from master cylinder to calipers all with stainless aeroquip ends.The rear chasis rails had started to blister so i chopped out all the rust until it was all good metal and welded in flush the same thickness of metal. I took all the floor to the bear metal on the under side once i had welded it up then i etch primed it up and carried on until finish... the car had every new piece i could get from ford but i had to improvise on a few nuts bolts washers anything cheers for the compliments i hope yours ends up how you want it.......cheers craig...