ok tried pulling them out really hard, almost pulling the car off its axel stands!

was pissing me off for about half hour, then got simple screw driver/lump hammer, and got the drivers side one out,

then put a long screwdriver in the hole, and carefully tapped the other one out.

only issue is they joints bent alot. were at right angles at some point, and im sure they also pulled apart as i was tugging.


are they screwed, or will they go back together ok? haynes said you shouldnt put them past 17.5 degrees?!?

gota put clutch in tomorrow, is it best to gently sand the flywheel down?