90_spec

So along with the resto of my Cabby im building a turbo engine for it also, Starting with an XR2i lump.
Im in the motorsport trade and now have a Pectel SQ6 which i shall be using,
Rescued an old shitter panasonic toughbook for mapping and have it now communicating.
Base map for a 4 pot in, few tweaks for coils, still not sure weather to go zetec coil or STD,
I going to try and keep the standard IAT and ECT sensors if i can, does anyone have a lin curve / calibration for them, i.e, resistance versus ohms(with their pullup value)
currently building a full motorsport engine inner harness and then engine outer harness with Autosport bulkhead connectors, (helps when you've been doing it 15 years), i can do that standing on my head.
So if anyone wants some help designing or building motorsport looms, im happy to help.
Done a few For ZEN Motorsport over the years, and Cosworth, etc





Pectel SQ6 on the bench getting some comms... after some help




Candles courtesy of the missus