Help with ECU
#1
I've found that life I needed.. It's HERE!!
Thread Starter
#2
Part of the Furniture
403's are the bosch grey injectors, but you will only find out what bhp it is capable of, if you know the rest of the set up it was intended for, i.e. cams compression ratio, turbo and so on.
some of these could be figured out if the ecu was calibrated for the engine you got, but there is no way of knowing if it was
The best solution would be to find out what is fitted to the engine, and then get a new chip from any tuner for that spec, or at the least yuo could find out what bhp the whole set up would make, not just the ecu
some of these could be figured out if the ecu was calibrated for the engine you got, but there is no way of knowing if it was
The best solution would be to find out what is fitted to the engine, and then get a new chip from any tuner for that spec, or at the least yuo could find out what bhp the whole set up would make, not just the ecu
#5
I've found that life I needed.. It's HERE!!
Thread Starter
How could you tell that is is written on the chip? what injectors would it need ?
Mark i have been in touch with Scott at EMTRON here is OZ looking at getting an ECU from them in the future, may just get the motor running on this one 1st then swap over later.
Mark i have been in touch with Scott at EMTRON here is OZ looking at getting an ECU from them in the future, may just get the motor running on this one 1st then swap over later.
Thread
Thread Starter
Forum
Replies
Last Post
DixieTheKid
Ford Sierra/Sapphire/RS500 Cosworth
2
14-09-2015 09:04 PM