how put standar wires in a gr A coil ? (cosworth)
#1
Part of the Furniture
Thread Starter
iTrader: (1)
Join Date: Dec 2005
Location: SPAIN
Posts: 191
Likes: 0
Received 0 Likes
on
0 Posts
how put standar wires in a gr A coil ? (cosworth)
the standar cosworth ignition coil have two conections, but the group A coil have four, 2 + and 2 - ..... only conect two in my two wires?
thanks
thanks
#3
Where the terminals are in pairs use just one connector from each pair for the neg and pos.
If you look very carefully down between the paired spade terminals so they are facing you, you wil see the relevant pos and neg on each pair.
The marking is a bit hidden, took me a few minutes as well!!
tabetha
If you look very carefully down between the paired spade terminals so they are facing you, you wil see the relevant pos and neg on each pair.
The marking is a bit hidden, took me a few minutes as well!!
tabetha
#4
Too many posts.. I need a life!!
Join Date: Dec 2004
Location: away with the fairies
Posts: 570
Likes: 0
Received 0 Likes
on
0 Posts
my standard coil has round terminals but the group A coil has spade terminals now can i just push the obviously round standard terminal connector onto one of the single spade connector pins on the group A terminal??? dont wanna snap the terminals
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
muz
General Car Related Discussion.
3
16-08-2015 12:57 PM
155lee
Ford RS Cosworth Parts for Sale
0
14-08-2015 11:21 AM