RST in a Mk1 Fiesta van
#1
Virgin
Thread Starter
Join Date: Dec 2009
Location: Coventry
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
RST in a Mk1 Fiesta van
I'm looking to put a RST engine from my mk3 fiesta into a mk1 fiesta van. Can anyone tell me if I need to cut the bulk head and or any mods to the inner arches? cheers.
#3
Too many posts.. I need a life!!
if you plan on putting the 5 speed box in you will also need to cut and modify the n/s chassis leg, but again there is a kit available to buy for this
#7
chatter 4 life
iTrader: (5)
Join Date: Sep 2004
Location: northallerton
Posts: 2,490
Likes: 0
Received 0 Likes
on
0 Posts
as siad inner arch on pass side and engine moutn plate, just cut the inner wing the put some box section in where u cut out to put strenth there, no need for tie bar mod or nowt, my mk1 fiesta van ran standed xr2 tie bars all i did was cut inner wing and put some box section round where i cut out and my mate done the same
Thread
Thread Starter
Forum
Replies
Last Post
JK12
Pictures, video & Photoshop Forum
33
26-04-2021 12:09 PM