My new toy ( not a ford)
#7
10K+ Poster!!
Very nice looking car!
Trending Topics
#8
Advanced PassionFord User
That looks rather nice, well done, top choice
#13
Regular Contributor
Thread Starter
is almost standard at the moment bar a trust down pipes stainless decat pipe .8 bar boost and a set if filters
its got r34 brembos and bc coilovers the dyno print out for 350bhp but its very linner no big spikes in power it fairly placid compered to my saph and its 32psi
iv got a realy good ecu but no point fitting it on standard turbos so i'm hoping to do a build maybe next year
got to recoupe some cash first
its got r34 brembos and bc coilovers the dyno print out for 350bhp but its very linner no big spikes in power it fairly placid compered to my saph and its 32psi
iv got a realy good ecu but no point fitting it on standard turbos so i'm hoping to do a build maybe next year
got to recoupe some cash first
Last edited by dissmalrs; 25-06-2016 at 08:22 PM.
#14
10K+ Poster!!
Does look awesome! Good investment too by the looks of things, if that's of any interest.
#15
PassionFord Post Whore!!
is almost standard at the moment bar a trust down pipes stainless decat pipe .8 bar boost and a set if filters
its got r34 brembos and bc coilovers the dyno print out for 350bhp but its very linner no big spikes in power it fairly placid compered to my saph and its 32psi
iv got a realy good ecu but no point fitting it on standard turbos so i'm hoping to do a build maybe next year
got to recoupe some cash first
its got r34 brembos and bc coilovers the dyno print out for 350bhp but its very linner no big spikes in power it fairly placid compered to my saph and its 32psi
iv got a realy good ecu but no point fitting it on standard turbos so i'm hoping to do a build maybe next year
got to recoupe some cash first
Mark
#16
Regular Contributor
Thread Starter
the early one are a bad for oil pumps because of he drive on the crank mine will do the same i recon at some point
iv got a life f88 for mine
The following users liked this post:
dissmalrs (02-07-2016)
Thread
Thread Starter
Forum
Replies
Last Post