Ford KA complex issue - please help!
#1
Virgin
Thread Starter
Join Date: May 2011
Location: South Wales
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Ford KA complex issue - please help!
Hi
I have a 1.3 54 KA.
- changed the heater module to stop ONLY hot air blowing, this was a success, after reconnecting the battery I had a engine management light come on.
- went to mates to use obd2 scanner, came up with p0030 fault code (Powertrain: H02S Heater control circuit Bank 1: Sensor 1) and couldn't complete a test on the fuel system because: "Open Loop: Has not yet satisfied conditions to go Closed Loop".
- replaced the sensor 1 on manifold £50 was the correct part lb1604
- reset fault code, but reappeared!
- there is voltage going to the sensor.
- Car is leaning to rich mixture, so it's drinking my fuel more
- There is no running problems, just using a lot more fuel.
Cheers
I have a 1.3 54 KA.
- changed the heater module to stop ONLY hot air blowing, this was a success, after reconnecting the battery I had a engine management light come on.
- went to mates to use obd2 scanner, came up with p0030 fault code (Powertrain: H02S Heater control circuit Bank 1: Sensor 1) and couldn't complete a test on the fuel system because: "Open Loop: Has not yet satisfied conditions to go Closed Loop".
- replaced the sensor 1 on manifold £50 was the correct part lb1604
- reset fault code, but reappeared!
- there is voltage going to the sensor.
- Car is leaning to rich mixture, so it's drinking my fuel more
- There is no running problems, just using a lot more fuel.
Cheers
#2
Too many posts.. I need a life!!
The 1.3 duratec model might have two lambda sensors, my sportka 1.6 has two but replacing the top one fixed the EML after a few miles of driving, the lower one is near the bend under the firewall
Thread
Thread Starter
Forum
Replies
Last Post
borboyous
Cars for Sale
6
22-08-2015 11:17 AM
TommysKeeper
General Car Related Discussion.
13
14-08-2015 08:22 PM