cossytonyt

ok mate i will crack on with it lol

hello mate.....

ok, you know were to start from''
1st thing is'' mount the new crossmember on to your engine, see were you need to cut and remmber that you need that bit more due to add on with weld!
next job is, looz all that brake pipe and 3-way!
then after that cut out the section between the strut towers!
Hopefully at this point you can get at the nuts on the legs!
after those are removed, you should be able to get your engine and box bolt together!
Then you can do a test fit, mark out were you need to mod the bulkhead seam lip, trim back with a grinder, leave about 2mm lip so it can be seam welded up.
remmber to remove hand brake, and gearbox stick suround!
Again do a trial fit, and see how the box fits in the tunnel, you may need to trim the gear stick hole back a bit.... then we can see wots'' wot'' from there mate... ok
plus are you going to put the mk1 on here, you should get some pics up mate...