Ryan

Afternoon Ryan, just checking if you got my PM with regards to fitting the ESCOS wiring loom that we spoke about a while ago on the Escos forum?. I could really do with it sorting before we sell the house if possible.
Thanks, Dan.

Hi mate i ,ve paid £65 into your account, michael james here, southend on sea can you let me know when you can send the fuel loom out
cheers pal , sorry for the delay
mike

Hi Ryan,

Not sure if u got my email. how do i go about ordering / paying for those connectors? Whats your contact number?

thanks,

Mike Perrin

how you doin mate can you remember if that t38 i bought off you was a 360 bearing cheers hows business with you busy

hi ryan your name was past on to me on hear as the one in the no.
i have problem with my 2wd saff in building .
i have no power to both coil wires or ingition module .
and the only way i can get the fuel pump to prime is to bridge the relay.
i have put a couple of listing on here about the fault in detail.
hope you can help and possibley supply whats needed.
carl

G day Ryan
Got those looms in the post to day
Thanks heaps

Graeme

Hello there Ryan,
You're a popular bloke! I understand you can supply cosworth looms. I have a 91 saph 4x4. I would like an idea of the price for the loom from the ecu to all the under bonnet engine sensors. I'm having a mare with mis fires at the moment, and you were recommended on the forum. Can you let me know if you can help, and how much it's likely to cost me.
Kind regards
Justin

Hi Ryan, can you supply an engine wiring loom to replace the original fitted to my 1987 3 door?
Thanks, Ian

Hi Ryan are you still on, sent a PM yesterday any chance of last bit of advice before I get stuck in to sourcing parts...Ian.

Hi Ryan, having problems with my loom, gone too far to rip out and start again. Will be in touch to buy some new sensor connectors shortly but before I do need to resolve a problem with fuel pump feed through relay. Have 12v+ going into fuel pump relay (pin 30) yet had only .5 v coming out on pin 87. Disconnected the idle speed sensor as it seemed to be going down to earth, this isn't right is it ? do I need to replace ? Now disconntected I get no voltage on pin 87, can you help ? getting frustrated with the whole thing now !.
ECU is an IAW45 any idea where I can get a wiring loom and explanation as to how this works. Any help would be much appreciated set up is in a kit car and did run well 2 yrs ago before undergoing restoration.