Any member with a code reader in the Derby area
#1
Wahay!! I've lost my Virginity!!
Thread Starter
Any member with a code reader in the Derby area
Hi All
Is there any members in the Derby area with a code reader for a Ford Mondeo 2005 TDCi 2.0 ltr
Had a code 401 EGR problem sorted that and need to change turbo pipe, Think its split fingers crossed that will be sorted but if the flashing EML is still there can this be erased with a code reader,
Would also like to add that cannot be done until 12th Dec, any advice or assistance most grateful
Rammer
Is there any members in the Derby area with a code reader for a Ford Mondeo 2005 TDCi 2.0 ltr
Had a code 401 EGR problem sorted that and need to change turbo pipe, Think its split fingers crossed that will be sorted but if the flashing EML is still there can this be erased with a code reader,
Would also like to add that cannot be done until 12th Dec, any advice or assistance most grateful
Rammer
The following users liked this post:
rammer (01-12-2015)
#3
Wahay!! I've lost my Virginity!!
Thread Starter
Thank you I have to take battery off and re charge when home Was looking on the neg side thanks again knew someone on here would be able to advise
Rammer
Rammer
#4
I live in Derby and have a basic code reader that I bought when I had a 2008 mk7 Transit and the EGR valve used to gum up.
It put the engine light on and I used this to turn it off.
If you put ford fault code reader into Ebay it is similar to those ones.
If that will fit your car I can turn the light out for you.
It put the engine light on and I used this to turn it off.
If you put ford fault code reader into Ebay it is similar to those ones.
If that will fit your car I can turn the light out for you.
The following users liked this post:
rammer (02-12-2015)
#5
Wahay!! I've lost my Virginity!!
I got a cheap obd2 bluetooth reader of ebay and use the "torque" app to reset my eml light as I by passed the egr causing it to log a code every now and then....I'm near j28 m1 and A38 if you need one to borrow m8
The following users liked this post:
rammer (02-12-2015)
#6
Wahay!! I've lost my Virginity!!
Thread Starter
code reader
thank you for all the replies I am nearer to A 38 M1 junction as I am in Ripley area, so I will PM you mate , It has been suggested that the codes will go when I disconnect the battery, looking on the negative side I suppose
Thanks again
George
Thanks again
George
Thread
Thread Starter
Forum
Replies
Last Post