Refitting a cobra alarm in my fiesta
#1
Virgin
Thread Starter
Join Date: May 2011
Location: Belfast
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Refitting a cobra alarm in my fiesta
Lads, need to reconnect my cobra alarm I took out a few years ago when I lost both fobs.
Are there any complications in doing this?
It looks like he has cut 3 cables. 2 that are connected to the big pin thing that connects to pic 2 below. Get them soldered? Then he also has cut the cable that connects to Y in pic 1. Didn't see where this was.. Get it soldered too?
I take it TX and RX are pic 4 below?
http://oi57.tinypic.com/28i4y2s.jpg
http://oi62.tinypic.com/29gmoaw.jpg
http://oi61.tinypic.com/9saps3.jpg
http://oi57.tinypic.com/2ignhgx.jpg
Thanks in advance!
Are there any complications in doing this?
It looks like he has cut 3 cables. 2 that are connected to the big pin thing that connects to pic 2 below. Get them soldered? Then he also has cut the cable that connects to Y in pic 1. Didn't see where this was.. Get it soldered too?
I take it TX and RX are pic 4 below?
http://oi57.tinypic.com/28i4y2s.jpg
http://oi62.tinypic.com/29gmoaw.jpg
http://oi61.tinypic.com/9saps3.jpg
http://oi57.tinypic.com/2ignhgx.jpg
Thanks in advance!
#3
Moderator
iTrader: (11)
cobra alarms have the module built in for central locking so most cut wires on installation or are bridged at this point when hooking up, different cars have different wiring so its hard for anyone to 2nd guess exact wiring for your vehicle
Y in pic one is the antenna and is normally around 8inch long and does not connect to anything
pic 4 is the ultra sonic sensors that simply plug into rx/tx
Y in pic one is the antenna and is normally around 8inch long and does not connect to anything
pic 4 is the ultra sonic sensors that simply plug into rx/tx
Last edited by STeve; 19-09-2014 at 08:52 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Steve Escos
Ford RS Turbo Parts for Sale
0
01-10-2015 06:57 AM