focus sub
#1
Virgin
Thread Starter
Join Date: Jun 2009
Location: highland
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
focus sub
Hi, the sub in my focus blew and i got another secondhand,(kenwood t10 0878 08)The original sub had just 1 voice coil but the kenwood has 2, i have just wired to one set of connectors but now it seems to be trying to play higher frequencys as well as the low so do i need to wire it differently ie http://a248.e.akamai.net/pix.crutchfield.com/ca/le... or http://a248.e.akamai.net/pix.crutchfield.com/ca/le...
problem is i dont know anything about the sub or the amp, the amp is the original option one and i cant find info on the sub, help.
problem is i dont know anything about the sub or the amp, the amp is the original option one and i cant find info on the sub, help.
#3
Virgin
Thread Starter
Join Date: Jun 2009
Location: highland
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Ok was planning going down a different route with this now as i have an old kenwood amp with lp filter so how do i wire it, what goes where.I have 2 red wires 2 black wires 1 red and white 1 black and grey and 1 white and black, the amp is rca input, thanks.
#6
If it has 2 voice coils and your original was 1 then you have to link the 2 voice coils together as you maybe using the wrong impedance. You need the positive on the one coil linking to the negative on the other coil.
Thread
Thread Starter
Forum
Replies
Last Post
wowk
General Car Related Discussion.
4
30-03-2021 07:49 PM