Do you want to build a 4x4 RS Mk1 Focus provisionally SOLD
#1
Regular Contributor
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
Do you want to build a 4x4 RS Mk1 Focus provisionally SOLD
I was building a modified RS2000 4x4 which I now due to health cannot do now, I built up a very high spec I4 2.3 to run in it (which is also for sale) but what would be of interest to RS Focus people is that I had a Mitsubishi EVO 6 gearbox & LSD front transfer box 8000mile on it from new re-machined (NOT an adaptor) to fit Ford bolt pattern the same as on the Focus RS Zetec. I have the gearbox with the transfer box, prop shaft & a EVO RS rear diff which are LSD not the yew control type plus the drive shafts
To break the price down the gearbox, transfer box front shafts (Ford Escort outers) & propshaft £1600
Rear EVO RS diff with front rubber mounts & EVO drive shafts £1300 (these are very sort after)
So £2900 for this & it cost me a lot more than that to have it all done NOW £2500!!!!!!!!! THIS WOULD MAKE ONE HELL OF A RS FOCUS (NOW SOLD)
I also have a new AP racing clutch organic new cost £700 ish sell for £400
To break the price down the gearbox, transfer box front shafts (Ford Escort outers) & propshaft £1600
Rear EVO RS diff with front rubber mounts & EVO drive shafts £1300 (these are very sort after)
So £2900 for this & it cost me a lot more than that to have it all done NOW £2500!!!!!!!!! THIS WOULD MAKE ONE HELL OF A RS FOCUS (NOW SOLD)
I also have a new AP racing clutch organic new cost £700 ish sell for £400
Last edited by IAN RS2k; 26-04-2015 at 02:58 PM.
#2
Regular Contributor
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Posts: 238
Likes: 0
Received 0 Likes
on
0 Posts
Price dropped this would sell for £2500 in bits I have seen the rear RS diffs sell £1700 the transfer box £600 then the box would just need the bell housing side swopped to make a good gearbox then the propshaft & gear stick are all worth money so its a fair price for the Ford conversion
#5
Gearbox
Hallo Ian, please can i ask you for your contact? I woul like to get some info on the 4x4 build you have done. Iv got FRS mk1 that i would like to convert..
Im from Czech Republic , but dont mind callig you for few minutes if you dont mind to share some knowledge
Best regards
Tom
Im from Czech Republic , but dont mind callig you for few minutes if you dont mind to share some knowledge
Best regards
Tom
Thread
Thread Starter
Forum
Replies
Last Post