New wiring loom
#1
15000
Thread Starter
New wiring loom
After deciding to convert from mfi to efi I'm looking to also renew the loom, is there anywhere/body who does them and how much do they cost ?
Cheers for any help.
Cheers for any help.
#4
15000
Thread Starter
Looking at a stand alone ecu, had a look at the gen8 on boost monkeys web site but I gather there is no loom available at present for that.
I'm at the point of a full resto on he Erst which was mfi, Iv built a zvh lump and have the fiesta flywheel and inlet ect, this is the first one Iv owned so on a steep learning curve and don't want to be doing jobs twice, any info at this point is much appreciated.
Cheers Chris .
I'm at the point of a full resto on he Erst which was mfi, Iv built a zvh lump and have the fiesta flywheel and inlet ect, this is the first one Iv owned so on a steep learning curve and don't want to be doing jobs twice, any info at this point is much appreciated.
Cheers Chris .
#5
Balls Deep!
iTrader: (4)
You won't find any new management that comes with a loom already made up for an RST, that's the job of whoever installs it, there's also many options too so a loom for one RST may be quite different to a loom for another RST.
Last edited by Karlos G; 01-03-2015 at 02:18 PM.
#6
Ask me a question!
iTrader: (1)
I disagree there are 3 systems I supply to my customers with new wiring looms custom made to fit pretty much any fwd setup using most engines from cvh zetec duratec etc taking into account any custom one off stuff.
Not a for sale add just stating that there IS off the shelf systems with looms from omex, weber, kms, pectel, emrald, gems, life racing to name a few..
Not a for sale add just stating that there IS off the shelf systems with looms from omex, weber, kms, pectel, emrald, gems, life racing to name a few..
Trending Topics
The following users liked this post:
luke19790_3 (02-03-2015)
#10
Balls Deep!
iTrader: (4)
I disagree there are 3 systems I supply to my customers with new wiring looms custom made to fit pretty much any fwd setup using most engines from cvh zetec duratec etc taking into account any custom one off stuff.
Not a for sale add just stating that there IS off the shelf systems with looms from omex, weber, kms, pectel, emrald, gems, life racing to name a few..
Not a for sale add just stating that there IS off the shelf systems with looms from omex, weber, kms, pectel, emrald, gems, life racing to name a few..
How does that work with options like ALS, boost control, programmable outputs/inputs, lambda, launch control, flat shift, etc? Do you just have loads of wires left over somewhere? Separate sub looms? Or are those options not available if they chose a pre-made loom? How would you know how long to make them and what connectors to use? Just curious as there's so many options and choices... no two installs are alike I find.
Last edited by Karlos G; 01-03-2015 at 09:02 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mark RS
Ford RS Cosworth Parts for Sale
7
12-10-2015 06:01 AM
muz
General Car Related Discussion.
7
30-09-2015 08:29 AM