HaggisTurbo

Hi All,

Doing the ST170/Blacktop Zetec Turbo conversion and I am having some trouble sourcing an EFI flywheel.

Is it just the Fiesta RS Turbo one I can use or can i use the Zetec RS1800 one? or the xr2i one? or even an xr3i 16v?

Are they all the same or is it only CVH one I can use.

I am mating it to a Ka Gearbox hence the need for the flywheel

thanks

Daveysaff

iTrader: (9)

Any EFi cvh item should be fine

xrmalin

But if you use a cvh flywheel you'll have to open the mounting bolt holes up by a mm or so so that the Zetec bolts fit through it

studabear

1.8 focus petrol flywheel Im sure I've read that it fits, no drilling either.

HaggisTurbo

My query was because Its an ST170 bottom end so I would have thought any zetec 2.0 litre flywheel would have done, connecting to an ib5 ka box? Or is there a specific reason it needs to be a CVH one? Confused.com lol

Thanks for your help folks

studabear

2litre focus had a mtx box 1.8 had ib5

xrmalin

The cvh flywheel is lighter too

studabear

A few efi 2i/3i cars on ebay for breaking, might get a flywheel from one of them?

HaggisTurbo

Hi Stu got a Flywheel from a 1.8 Xr2i 16v which had a ib5 gearbox.

Karlos G

iTrader: (4)

This.
Should be fine then, you use an RST clutch too which is why a 220mm flywheel is also needed.

HaggisTurbo

Yup just need to organize a clutch and I can start building it all up.

Going to give it a good clean and a paint first though