HELP With CPS
#1
Regular Contributor
Thread Starter
Join Date: Dec 2004
Location: Birmingham
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
HELP With CPS
Right i am changing the cps sensor tomorrow due starting problems on my ST Escos
Can anyone tell me how to do this, as i dont have a clue
thanks in advance
Can anyone tell me how to do this, as i dont have a clue
thanks in advance
#2
Get car on ramps, locate the CPS at front of engine at about the 7 o'clock posytion around the crank pulley, reach up and undo connector, take out two small(8mm) bolts that hold sensor to bracket on front of sump, reverse for new one.
Make sure gap is 0.6mm - 1.0mm between sensor and a lug on crank pulley, reconnect job done.
tabetha
Make sure gap is 0.6mm - 1.0mm between sensor and a lug on crank pulley, reconnect job done.
tabetha
#6
Regular Contributor
Thread Starter
Join Date: Dec 2004
Location: Birmingham
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
thanks sensor is on now
one thing i did realise though was when i started it, there seemed to be like a knocking noise under the cambelt cover
any thoughts anyone
one thing i did realise though was when i started it, there seemed to be like a knocking noise under the cambelt cover
any thoughts anyone
Thread
Thread Starter
Forum
Replies
Last Post
DixieTheKid
Ford Sierra/Sapphire/RS500 Cosworth
11
06-06-2020 11:20 AM
wheelwizardrefurbs
Technical help Q & A
8
18-09-2015 08:59 PM
lockie
Ford Sierra/Sapphire/RS500 Cosworth
0
31-07-2015 10:03 PM