RPM-counter???
#1
DANISH cosworth abuser
Thread Starter
Join Date: Aug 2004
Location: Holbćk, denmark
Posts: 1,467
Likes: 0
Received 0 Likes
on
0 Posts
RPM-counter???
Hi guys.
Does anybody know how to connect the orriginal rpm-counter to an aftermarket management system?
I know its the green wire that is the signal wire, but it still doesent work??
Any help would be nice
Thanx
Does anybody know how to connect the orriginal rpm-counter to an aftermarket management system?
I know its the green wire that is the signal wire, but it still doesent work??
Any help would be nice
Thanx
#2
Aftermarket ECM should accept a variety of inputs for ignition, and accordingly instructions for it will tell you which ECM feed to use, it may need re setting on compy to enable different output config, ask ECM maker for advice.
tabetha
tabetha
#3
PassionFord Post Whore!!
Join Date: Sep 2003
Location: Macclesfield - you'll never leave....!
Posts: 4,519
Likes: 0
Received 1 Like
on
1 Post
you may need to short out the supressor that is used on the std setup - it is located near the coil - ans is screwed to the inner wing - it has just t woies to to - undo the multiplug and short out the wires inside.