Advanced PassionFord User
Join Date: Sep 2005
Location: Staines, Middlesex
Posts: 1,995
Likes: 0
Received 0 Likes
on
0 Posts
The new engine was literally a bare block and head with the valves and pistons ect.
Everything to do the the Injecton system, sensors, pipes, cam, the lot are from the original engine.
I've just cracked off the injector pipe again and cranking it and a load of air came out followed by a dribble of diesel.
Does anyone know how to fully bleed the system?
I've connected a hand pump to the supply from the tank, to the outer pin on the filter and pumped till diesel came out. The I connected the other two pipe, cracked off all the injectors and pumped like mad for about 15mins, ( I didn't get any fuel out the injector pipes but I'm not sure your meant too, I know you do with TDDI)
Other than that it must be drawing in air somewhere as stated above.