little bit more, as its so close to xmas i havnt bothered ordering anything incase it never turns up, sp started on the rear diff
so here it is nice and filthy
back plate off to look inside the diff
3.62 so at least i know its the correct diff
driveshaft joints out, i wanted to see if one of them would fit in the front diff so i can get rid of the std pop joint that always break but its slightly too big, but i think if it coudld be machined down i could get it too work, but ill look into this at a later date
all cleaned up and a nice bit of paint on it
alls i need to do is get some new bolts for the diff late, and send the drive flanes in for elcetro plating, so this iwll be after xmas now
also as i mentioned earlier on in the thread i was thinking of cutting the boot floor out for easier access to the fuel pump incase ieve need it well, out came the jigsaw!!!
before
after
just got to give it some sealant underneath and a lick of paint, then get some carbon sheeting and some rivinuts